Float switch changeover, Cable length 1,0 m, depending on the connection zum Befüllen or draining.
The switch is designed as a changer. Depending on the connection, the pump switches off when a certain water level is exceeded or too low. The switch is actuated by a ball. The shift inclination is approx. 30 °.
Depending of the connection as
dry-run protection, switches off when suspended.
over-run protection, switches on when suspended.
- Switching capacity
- 10(8)A 250V~, 10(4)A 400V~
- Switching frequency:
- 50.000 switching cycles, VDE geprüft
- protection class
- Without Protective conductor, VDE-Reg.Nr. 6653
- Protection class
- IP68, waterproof
- Operating temperature
- Max. 60°C
- operating pressure
- Max. 0,1 bar
- H07RN8-F 3X1 mm² , max 90°C
- Cable length
- 1,0 m
- switching point draining
- On = top (floating)
Off = bottom (suspended)
- switching point filling
- On = bottom (suspended)
Off = top (floating)
The float switch is attached to the cable with a clamp. The switching path depends on the free cable length (min. 120 mm).
The free cable length must not be too short, as the cable is not sufficiently flexible. This is especially true for cold temperatures. If the length of the cable is too long, the float can float on the surface of the water without coming into the tilted position.
more cable length
more cable length dieses switchs finden Sie unter: Schwimmerschalter Wechsler EHZ-FS-C
Notes on delivery times1
The delivery time applies to deliveries to Germany.
Delivery times for other countries can be found at