Switch-plug combination for three-phase A.C. Current. for circular saws, planing machines, shredders or other machines and motors,
which after power failure and power recovery are not allowed to turn back on.
Required for machines for commercial operation, which do not have an engine brake, but are required to have one.
- 3-pole switching. Suitable for mains connection without neutral conductor
- Switching capacity up to 7.5 kW
- Braking electronics, braking current up to 16 A adjustable
- Motor protection depending on the construction 12 or 16 A, Non-adjustable
- Undervoltage release
- Phase inverter
- Splash water proof cover
The neutral conductor is not connected.
Not suitable for motors in delta connection, which for example need a voltage of 230V in the terminal box for a electromechanical brake.
If needed a brake can be tapped between a phase and a star point 230V for motors in star connection.
The motor protection is according to the nominal current des Motors (+ ca. 10%)auszuwählen.
A connection for a thermal contact is not provided, because the motor is better protected with the overcurrent protection.
Installation / connection (refer to wiring diagram) / brake
The switch is screwed on the housing base. Grid dimension of the screws: 68 x 68 mm.
The brake is by factory setting set to the lowest current.
The braking current can be adjusted with a potentiometer.
- Voltage Ue
- 400 V~
- Current le
- 16.0 A
- U-spg. 7.5kW, 400V~
- Switching capacity
- 7.5 kW 400V~/AC-3
- Braking current
- Up to 16A adjustable
- Type of actuation
- Mechanically on/off
- CEE 3P+N+E , 16A
- Housing material
- Polypropylene PP
- Mounting position
- Protection class
- IP54, splash water proof
- Connection cable
- 1 m H07RN-F G1,5
- Mounting dimensions
- 68 x 68 mm
Notes on delivery times1
The delivery time applies to deliveries to Germany.
Delivery times for other countries can be found at