Switch-plug combination for three-phase A.C. Current. for circular saws, planing machines, shredders or other machines and motors,
which after power failure and power recovery are not allowed to turn back on.
Required for machines for commercial operation, which do not have an engine brake, but are required to have one.
- 3-polee AC switch-plug combination, suitable for mains connection without neutral conductor
- Switching capacity up to 7.5 kW
- Braking electronics, braking current up to 16 A adjustable
- Undervoltage release
- Phase inverter
- Connection possibility for thermal contact
- Splash water proof cover
The neutral conductor is not connected.
Not suitable for motors in delta connection, which for example need a voltage of 230V in the terminal box for a electromechanical brake.
If needed a brake can be tapped between a phase and a star point 230V for motors in star connection.
Installation / connection (refer to wiring diagram) / brake
The switch is screwed on the housing base. Grid dimension of the screws: 68 x 68 mm.
The blue wire is not a neutral conductor, it's the connection for the thermal contact.
If the motor does not have a thermal contact, the blue wire has to be connected with the grey wire on the terminal board.
The brake is by factory setting set to the lowest current.
The braking current can be adjusted with a potentiometer.
- Voltage Ue
- 400 V~
- Current le
- 16.0 A
- U-spg. 7.5kW, 400V~
- Switching capacity
- 7.5 kW 400V~/AC-3
- Braking current
- Up to 16A adjustable
- Type of actuation
- Mechanically on/off
- CEE 3P+N+E, 16A
- Housing material
- Polypropylene PP
- Mounting position
- Protection class
- IP54, splash water proof
- Connection cable
- 1 m H07RN-F G1,5
- Mounting dimensions
- 68 x 68 mm
Notes on delivery times1
The delivery time applies to deliveries to Germany.
Delivery times for other countries can be found at