Capacitor with cable connection for the operation of single-phase AC motors, e.g. Of concrete mixers, garden pumps, small circular saws.
Usable for continuous operation and intermittent operation
Self-healing capacitor (MKP) in aluminium housing with cap, cable routing to the side, overpressure disconnector, base screw
Note regarding voltage information
The voltage information refers to the dielectric strength and not the operating voltage. The capacitor can be used with a 230V AC motor.
- 10 µF
- Capacity tolerance
- ±5% nominal value
- Climate class
- 25/85/21 according to IEC 60068
- Protection class
- IP 65 (with Kappe)
- Operating temperature
- -25° up to +85°C (UL:-25°C)
- Operating mode
- Continuous operation or
Intermittent operation AB 25% ED, SD 4h
Intermittent operation AB 20% ED, SD 24h
- Safety class
- Service life class
Class A - 30.000h - 420V (1-30 µF)
Class B - 10.000h - 470V (1-30 µF); -420V (35-80 µF)
Class C - 3.000h - 470V (35-80 µF)
Class D - 1.000h - 500V (1,5-30 µF)
- Mains frequency
- 50/60 Hz
- Filling material
- Environmentally friendly vegetable oil
- Cable 2 x 0.75 mm², length 300 mm
- Dimensions Ø x length
- 35 x 91 mm
- Base screw
- M8 x 10
Capacitors are wear parts, which fail under extreme conditions or at reaching their lifetime.
Hydra motor capacitors are manufactured with a build-in overpressure disconnector.
In case of failure, the capacitor will expand in the axial direction up to about 9 mm. Due to the expansion, the thinner section of the fuse will break and the capacitor will be disconnected safely from the mains.
Hydra capacitors are certified by the VDE Testing and Certification Institute and fulfill the regulations of safety class P2 according to EN 60252.
Notes on delivery times1
The delivery time applies to deliveries to Germany.
Delivery times for other countries can be found at