AC switch-plug combination for circular saws, planing machines, shredders and other machines, which after power failure and power recovery are not allowed to turn back on.
Required for machines for commercial operation, which do not have an engine brake, but are required to have one.
- 2-pole switch (Contactor)
- Switching capacity up to 3 kW
- With braking electronics, braking current up to 10 A adjustable
- With undervoltage release
- Connection possibility for thermal contact
- Including splash water proof cover
Installation / connection (refer to wiring diagram) / brake
The switch is screwed on the housing base. Grid dimension of the screws: 68 x 68 mm.
The cable outlet is on the side of the housing base, by factory setting on the opposite side of the plug.
by rotating the base, the cable can be routed to all 4 sides.
The brake is by factory setting set to the lowest current.
The braking current can be adjusted with a potentiometer.
- Voltage Ue
- 230 V~
- Current le
- 13.5 A
- KB-04, 230 V/3s1ö~
- Switching capacity
- 3.0 kW 230V~
- Braking current
- Up to 10 A
- Type of actuation
- Mechanically on/off
- Safety plug (Type F, CEE 7/4 plug, CEE 7/7 plug),16 A
- Housing material
- Polypropylene PP
- Mounting position
- Protection class
- IP54, splash water proof
- Connection cable
- 1 m H07RN-F 6 G1,5
- Mounting dimensions
- 68 x 68 mm
- Customs tariff number
- Country of origin
Notes on delivery times1
The delivery time applies to deliveries to Germany.
Delivery times for other countries can be found at